• Nutool CH10 Pillar Drill - Drive Belt: A

Nutool CH10 5-speed bench pillar drill replacement drive belt.

Belts available for the below variants;

  • A: CH10 - 5 spindle speeds - 525, 916, 1330, 1900, 2660 RPM fitted with a 1400 RPM motor.
  • B: CH10 - 5 spindle speeds - 515, 915, 1430, 1950, 2580 RPM fitted with a 1420 RPM motor.
  • C: CH10 - 5 spindle speeds - 515, 915, 1430, 1950, 2580 RPM fitted with a 1300 RPM motor.
  • D: CH10 - 5 spindle speeds - 600, 900, 1250, 1750, 2600 RPM fitted with a 1300 RPM motor.
  • E: CH10 - 5 spindle speeds - 520, 900, 1320, 1880, 2620 RPM fitted with a 1300 RPM motor.


Important!

There are lots of variants of this model that take different-sized belts so please check the spindle speed range and the motor speed of your model - the spindle speeds can be found either on the badge on the front of the drill or under the belt guard cover and the motor speed (RPM) can be found on the side of the motor.
The spindle speeds and if stated the motor RPM must match up exactly otherwise the belt may not fit - please contact us if you are unsure which belt you need.



Write a review

Note: HTML is not translated!
    Bad           Good

Nutool CH10 Pillar Drill - Drive Belt: A

  • £4.50


Available Options